Follow these instructions to add updated Niagara core files and Onyxx drivers to JENEsys ProBuilder™
N4.10.1.36 (Niagara Workbench) to install them on a JENEsys Edge 534 and connected Onyxx XM 34IOs.
BEFORE PROCEEDING
Updating a JENEsys Edge 534 and connected Onyxx Extender Modules
requires (1) installing the latest files, and; (2) performing a separate action
to update firmware and more. The process is described in these
instructions.
Estimated time: 3mns per JENEsys Edge 534, 3mns for each connected Onyxx Extender Module
❶ Arrange the files
With ProBuilder closed, place the following files into:
C: Users\[your username]\Niagara4.10\JENEsys[Workbench]\sw\inbox:
① Lynxspring-azul-zre-compact3-JENE-EG534.dist
② Lynxspring-linux.dist
③ nre-config-Lynxspring-JENE-EG534-N4.dist
④ nre-core-Lynxspring-linux-armhf-JENE-EG534-N4.dist
the following files into:
C:\JENEsys\JENEsys-ProBuilder-4.10.1.36\cleanDist:
① nre-clean-Lynxspring-edge534-n4.dist
② os-conversion-Lynxspring-edge534-n4.dist
and the following files into:
C:\JENEsys\JENEsys-ProBuilder-4.10.1.36\modules, replacing any previously installed versions:
① onyxxDriver-rt.jar
② onyxxDriver-wb.jar
③ platOnyxx-rt.jar
❷ Commission the JENEsys Edge 534
Commission the JENEsys Edge 534 using the Commissioning Wizard with at least the following
selections:
• Install/upgrade core software from distribution files, and;
• Upgrade All Out of Date [modules], adding
o onyxxDriver-rt.jar
o platOnyxx-rt.jar
Firmware and other updates are applied via a hidden action on the Onyxx
Network (with onyxxDriver.jar.4.10.1.36) in a running Station. A Station is
needed. Leave an existing Station on the device, transfer one during this
NOTE
commissioning process, or transfer one later using Station Copier.
❸ Unhide the ‘RunOnyxxUpdates’ action
① Connect to a running Station on the target JENEsys Edge 534 with an enabled OnyxxNetwork.
② In the Driver Manager view, or in the Nav Tree, right-click on the OnyxxNetwork and select Views >
Slot Sheet
③ Unhide the 'update' action by:
• highlighting the RunOnyxxUpdates action, and;
• right-clicking, selecting Config Flags, and deselecting Hidden
ALERT
Consider the following notes before continuing:
• interrupting the action may cause damage to the JENEsys
Edge 534 and connected Onyxx Extender Modules
• all outputs will be set to '0' and Niagara will be temporarily
unavailable to control your system
❹ Update the JENEsys Edge 534
In the Driver Manager view, or in the Nav Tree, right-click on the OnyxxNetwork,
• select Actions > Run Onyxx Updates
Monitor the progress of the update in ProBuilder at: [Target host] Platform > Application Director to
avoid interrupting the update. The process is complete when you see:
"------> All Onyxx Upgrade Processes Have Completed <------"